Recent content by Earache

  1. E

    Hi to everyone

    Welcome Yardbird!
  2. E

    Colorado - Rally /Meet July 26-28, 2019

    [Earache deleted his posts, so I'm commandeering this one and changed the title. - CW] DATES: July 26-28, although early birds will start to come in on the 24th or 25th. LOCATION: The area of Ouray, Colorado VENUE: Possibly at the KOA. If you guys want this edited, just pm AvGeek or I.
  3. E

    Hello from South Yorkshire, UK

    Hello Ressie from the always sunny and warm Colorado Rockies. Good luck with your decision, either bike will be great. Eric
  4. E

    Hello, from Brazil

    Hi Diego and welcome!
  5. E

    Colorado Check-in!!!

    Eric 2018 Tenere From Black Hawk (just off of Peak to Peak)
  6. E

    where did you TAKE your Tenere today?

    Headed south from home to St. Elmo and back - about a 300 mile jaunt with about 35 miles of dirt/gravel roads. Nice day for it....
  7. E

    ADV helmet quandary

    Al though I wear a Arai XD4, my next helmet is going to the Suomy MX Tourer : Had a few Suomy road helmets and always liked their fit, finish and liners, slightly cheaper than the Arai, although that';s not really a factor in my selection, Just like their fit.
  8. E

    Wanted: OEM rear rack

    Thanks, I am looking for just the top part. I think Buelligan has me sorted out at this point. Thanks!
  9. E

    I think I lined one up already - told the guy I'd take it anyway., If that falls through, I'll...

    I think I lined one up already - told the guy I'd take it anyway., If that falls through, I'll get back to you. Thanks very much! Eric
  10. E

    Wanted: OEM rear rack

    Private message sent.
  11. E

    Yes, the OEM stock rack. Let me know how much ya want for it and postage. Thanks, Eric

    Yes, the OEM stock rack. Let me know how much ya want for it and postage. Thanks, Eric
  12. E

    Wanted: OEM rear rack

    I checked and they appear to be the same for Gen 1 and Gen 2. PM me and ket me know how much you want for it. Thanks! Eric
  13. E

    Broken stock side case latch….

    That would certainly speed up any CNC or 3D printing operations. I'd guess a nice DXF file would be the thing to have.
Top